Logitek-electronic-systems JetStream Audio Networking Platform Bedienungsanleitung

Logitek Electronic SystemsLogitek Electronic SystemsJetStream MINI Reference ManualRevision 2.2Feb 2012

2 UnpackingThis section details what you should do when unpacking your newly arrived JetStream MINI.Parts ListThe exact list of parts received will va

3 Physical InstallationThis chapter covers basic installation and cabling information, and details some cabling examples. As preferences and technique

Data CableRecommended cable for the Control Surface data is CAT5 cable. The maximum length cable for Control Surface connections is 1000 feet (300 met

4 System ComponentsPower Supply UnitA switching 110/220 volt power supply is mounted internally inside the JetStream MINI. Connect the mains to the st

LED DisplayThe JetStream MINI has an LED display on the front and rear of the unit. These LEDs show the status of the unit, and information is display

Rear Panel Connections – First Generation (s/n 1-199) VGA – (installed with purchase of JetNet Audio Networking option) Allows for connection of a

RS-232 – (Installed on selected units only) Used in special installations for serial control of a video router.If a Second Generation DSP/Network card

AUDIO NET 2: Located on the DSP card. This is a gigabit Ethernet connection. When automatic failover is implemented, this will be the secondary audio

GPI Inputs & OutputsThe JetStream MINI provides 12 logic input connections along with 16 relay closures for external device control. Three GPI in

If integrating the JetStream with an AoIP system made by another manufacturer, connect an AES output to the External Sync input of one JetStream as de

Logitek Electronic Systems, Inc.5622 Edgemoor DriveHouston, Texas 77081USATel +1-713-664-4470Fax +1-713-664-4479Email [email protected] www

Surface Connections – Second Generation (s/n 200-299)Logitek JetStream MINI Reference Manual 20

Logitek JetStream MINI Reference Manual21

Control Surfaces (Audio Consoles) and Control Panels (Guest Turrets and router control heads) connect via RS-485 to the JSM-DSP card, which is labeled

Audio CardsThe JetStream MINI will accept from one to eight audio cards in slots A-H, which can be either analog or digital. JSM-AIN-RJ Analog Input C

 See Appendix C for connector pinouts.JSM-MICIN-RJ Analog Input CardThe JSM-MICIN-RJ card provides 4 microphone pre-amplified inputs using RJ-45 conn

JSM-AOUT-RJ Analog Output CardThe JSM-AOUT-RJ card provides 8 mono or 4 stereo inputs using RJ-45 connectors, following the StudioHub+ wiring standard

5 ConfigurationFirst Generation JetStream Configuration (s/n 1-199)Configuration of the Control Surface port is accomplished in conjunction with confi

Second Generation JetStream Configuration (s/n 200 & up)Configuration of the Control Surface port is accomplished in conjunction with configuratio

6 OperationThis chapter covers the basic operation of the JetStream Mini.Initial Power-UpDepending on your distance from Logitek Electronic Systems’ f

Resets from AEConfig & JetStream ServerThe following resets are performed from the JetStream Server and AEConfig PC applications:Soft ResetA Soft

Document RevisionsDate Revision Author NotesOctober 2010 1.0 John Davis, CBNT First release of JetStream MINI v1.0 Reference ManualDecember 2011 1.1 J

7 MaintenanceThe Audio Engine uses multi-layer boards with surface mount technology. As such, the majority of the engine and its cards are not user-se

Component ReplacementCard swap-outIf you need to swap a card with an on-site spare, you can simply unhook the blue tab from the card, pull up on the c

Contacting SupportNorth AmericaContact the factory directly via phone: (877) 231-5870 Toll Free or +1-713-664-4470 or email [email protected]

Appendix A Using AEConfig First Generation JetStream AoIP routers that do not have a built-in PC or who have the embedded PC but have not upgraded to

JSM-MIC IN: 4/8 input Microphone Preamp card. Assign an IO24A in AE Config to the slot where this is installed and only assign the first 4 input pins

JSM-DIN: 4 or 8 (depending upon RJ or DB card type) AES/SPDIF Digital Input card. Assign an IO8D in AE Config to the slot where this is installed and

JSM-AOUT: 8 mono/4 stereo Analog Output card. Assign an IO24A to the slot where this is plugged in and use the first 8 channels in the software. Do no

The columns in the grid represent the outputs; the pink rows represent inputs, green rows represent DSP outputs. Right click to create an I (Initial R

Important note on slots G & HIf slots G&H have cards installed, they must both be inputs or both be outputs. If the directions are mixed, the

Streaming Audio – The Executive SummaryNetworked audio is sent out as multicast IP streams. Each stream is assigned a different IP address automatical

Contents Document Revisions...3 Conte

Assigning an Output to the Network In AE Config, create a new output. Assign it the appropriate number of channels (1 for mono, 2 for stereo). Give it

Now, to assign the pins. The JetStream will look for any output that is assigned a pin with an invalid number and know that it is destined for the net

Defining Non-Logitek Network SourcesA small text file is kept in D:\Logitek named JSM_Net_Def.txt. Multicast information about AoIP sources from non-L

Appendix B Specifications GeneralCard slots: 1 Audio processor, 1 Network processor, 1 GPIO, 8 Audio I/OLocal audio I/O: 64 channels max (mono RJ-45)

Analog Input CardNumber of Channels: 8 mono inputs, may be combined for stereoConnectors: 4 StudioHub format RJ-45 sockets with audio presence indica

Digital Output CardNumber of channels: 4 outputs (RJ) or 8 outputs (DB) (2 mono may be combined into 1 output)Connector: 4 StudioHub format RJ-45 soc

Appendix C Pinout DataAudio I/O with RJ-45 ConnectorsTIP: The StudioHub+ standard calls for all connections being electronically balanced.TIP: Pre-

Audio I/O with DB ConnectorsDB25M plugs are required.Audio Inputs/OutputsPin Connection Pin Connection1 I/O 1 + 14 I/O 2 +2 I/O 1 - 15 I/O 2 -3 Ground

GPIOThere are four DB-15 connectors, with 3 GPI inputs and 4 GPI outputs each. The contacts of the internal electronic relays are rated at 50 volts DC

JSM-DSP (Surface)Port 1 to 4 – RJ45Pin Cable Color Connection1 White/Orange Cue -2 Orange Cue +3 White/Green RS-485 Tx -4 Blue RS-485 Rx -5 White/Blue

JSM-DOUT-RJ Digital Output Card...25JSM-DOUT-DB Digital Output Card..

RJ-45 to DB-9 Adaptor Color CodesPin Color1 Orange2 Yellow3 Green4 (no connect)5 White6 Blue7 Black8 Red9 BrownLogitek JetStream MINI Reference Manual

Logitek JetStream MINI Reference Manual51

Appendix D Microphone Phantom PowerPhantom Power on the JSM-MIC-DB or JSM-MIC-RJ cards may be enabled by selecting Cue @ Infinity in AEConfig. However

Appendix E USB To Serial ConverterFirst generation JetStreams (serial numbers 199 and below) that do not have the embedded PC installed for networking

Set the DIP switches as shown:Logitek JetStream MINI Reference Manual 54

Two Year Limited WarrantyLogitek Electronic Systems, Inc. warrants its professional equipment (excluding Logitek Software,which is covered by a separa

Network & Video Processor Card...45Appendix C Pinout Data...

1 IntroductionAbout this ManualThis manual describes the installation and operation of the Logitek JetStream MINI.Intended AudienceThis manual is aime

About the JetStream MINIThe heart of every Logitek digital console is the JetStream audio router. With 8 slots for microphone input cards, analog inpu

System RequirementsThe JetStream Mini is designed to be installed in a standard 19” equipment rack. It is two rack-units high. The unit is convection-